6-6.
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
Note on Printed Wiring Boards:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
•
W : indicates side identified with part number.
•
: internal component.
f
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen from
(Conductor Side)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side) the parts face are indicated.
• VMP board is multi-layer printed board.
However, the patterns of intermediate-layer have not been
included in diagram.
• Indication of transistor.
C
Q
These are omitted.
B
E
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
W or less unless otherwise
4
specified.
•
f
: internal component.
• C : panel designation.
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
• A : B+ Line.
• B : B– Line.
• H : adjustment for repair.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: TUNER (FM/AM)
J
: CD PLAY (AUDIO)
L : CD PLAY (VIDEO)
E
: TAPE PLAY
a
: REC
j
: MD (VIDEO)
N
: MIC INPUT
• Abbreviation
EA
: Saudi Arabia model
SP
: Singapore model
TH
: Thai model
• Circuit Boards Location
SWITCH board
JACK board
LOADING board
21
21
POWER board
VIDEO board
TC board
VMP board (VMP41)
BD board
HCD-M80
MAIN board
CONTROL board