Installer's Information; Locating Your Gas Fireplace; Unit Assembly Prior To Installation - Regency Fireplace Products City Series CC40LE-NG12 Owners & Installation Manual

Locating Your Gas Fireplace

1. When selecting a location for your fireplace,
ensure that the clearances are met.
2. The appliance must be installed on a flat, solid,
continuous surface For example a wood, metal
or concrete floor or in a raised (on the wall)
application. The appliance must be installed on
a metal or wood panel extending the full width
and depth of the appliance.
3. The CC40LE/CC40RE Direct Vent Gas Fireplace
can be installed in a recessed position or framed
out into the room as in A and B. See Diagram
1.
A)
Corner Left
A
Diagram 1
B) Corner Right
4. For bedroom installations, check with local codes
before installation. This appliance is offered with
a remote control.
5. The CC40LE/CC40RE Direct Vent Gas Fireplace
is approved for alcove installations, see "Clear-
ances" section for details.
6. We recommend that you plan your installa-
tion on paper using exact measurements for
clearances and floor protection before actually
installing this appliance. Have an authorized
inspector, dealer, or installer review your plans
before installation.
Note:
For vent terminations refer
to "Exterior Vent
Locations" section.

Unit Assembly Prior to Installation

Before you start
The CC40LE/CC40RE has 4 standoffs, 2 on one side and 2 at the back that need assembly before
installation.
Side and Back Standoff Assembly CC40LE/CC40RE
The standoffs are shipped in a flat position and must be folded into shape and attached.
Take each standoff off the unit by removing one screw and bend into the correct shape. Slot the 2 tabs
of the stand off into the slots in the unit and attach the other end with one screw.
B
Back Standoff Assembly CC40LE/
CC40RE
Take each standoff off the unit by removing one
screw. Bend into the correct shape (see above).
Slot the 2 tabs of the stand off into the slots in
the unit and attach the other end with one screw.
Termination

installer's information

Standoff
locations
CC40LE/CC40RE
tooltip
CC40LE/CC40RE
City Series CC40E-12 |
requirements
27