Installing The Rear Frame; Installing Head Platform - PROAIM KITE-22 Setup And Operational Manual

PROAIM KITE-22 STARTER PACKAGE

Attach the bigger weight rod with L-Brackets, for this insert the rod into one L-Bracket then
add the black tube with white washers at both the sides, insert the rod into the other L-
Bracket and then add the black tube. Tighten the nut and then attach the knob at the end.

INSTALLING THE REAR FRAME


To mount the Rear section, align the Assembly's 'L' brackets to the tail of jib section and in-
sert the bolt with washers through one end of the section to the other. Slide the bolt
through and hand tighten.

Add weights (Not
closer knobs to secure properly.
INSTALLING THE HEAD PLATFORM

Install the Head Platform assembly (leveling arm up) to the end of the smallest section with
the provided bolt, shaft collars, washers and nut. Tighten all the Allen bolts and nuts to se-
cure properly.
NOTE: Add white washers as per requirement on both sides of jib section so that there is no
play in between head plate & Jib section.
Included) to the rear weight section at both sides and tighten the weight
9