Installing The Hub Assembly; Installing The Jib Sections - PROAIM KITE-22 Setup And Operational Manual

PROAIM KITE-22 STARTER PACKAGE

Match the holes of the bottom leg section with the upper leg section to secure the tripod
stand with the Steel locking Pins and tighten the knobs.
Warning: We have provided double locking precautions on Jib Stand; Pin is the first and pri-
mary locking, knob is the secondary locking, so

Fix the tripod stand with Spreader and tighten the top ratchet knobs of stand to secure it in
place.

INSTALLING THE HUB ASSEMBLY


Install the Hub Assembly by sliding the bottom of the hub assembly
into the stand's Mount opening.
Note : The Hub Assembly has several mounting holes. You can mount LCD
Monitor or Joystick box to this assembly if you want.
Warning: This is the Pan Friction Knob. Never pan the Jib with this knob
tightened.
If this knob turns while panning, it is too tight. Only tighten while parking
the jib !

INSTALLING THE JIB SECTIONS


Install the Section 7 & 6 (largest diameter section to the rear) to the vertical pivot point with the
long bolt, washers and nut. Tighten the nut properly to secure the section.
Knob
first lock the Pin to avoid slipping of stand.
6
Pin