Assembling The Rear Frame - PROAIM KITE-22 Setup And Operational Manual

PROAIM KITE-22 STARTER PACKAGE

Slide Section 5 into Section 6 and join with ring pin.

Install the pin at the first join holes of the sections and bolt, washers and nut from side at
the second holes of section.
First hole
Second Hole

Similarly insert all the sections one by one (small to the big) and install the pin and bolt ,
washers and nut to secure each section.

ASSEMBLING THE REAR FRAME


Take the two 16mm thick rods and two 25mm thick rods.
Attach these rods altogether so that it makes a rectangle
and for this insert the 16mm rods into slots of 25mm rods.

Attach the Allen bolts by screwing in with hand and tighten with Allen key at all the four
points to secure properly.
IMPORTANT
This Ring Pin is to avoid the play in Jib.
This knob is for tightening the Jib sections.
7