Installing The Stress Cables; Installing The Pan Tilt Head; Installing The Joystick Control - PROAIM KITE-22 Setup And Operational Manual

Starter package

Hide thumbs Also See for KITE-22:

Table of Contents

PROAIM KITE-22 STARTER PACKAGE

INSTALLING THE STRESS CABLE



Connect the Head Platform Leveling Cable by hooking the turnbuckle ends .



Attach the Pan Tilt Head with the Jib. There are 4

mounting holes on the pan tilt as well as the jib plate.

Align the holes and attach it with the screws. Tighten the

wing nuts to secure properly.



Adjust the mounting extension so that the pan motor is in the rear facing position before

mounting.



Install your cable starting at the camera end; leaving enough cable slack for the camera for

full pan & tilt movement, you may need to add Velcro to loop the cable around the jib arm.



Install and hookup the pan & tilt joystick box on Jib Frame. Connect the wires with the Joy-

stick Control Box.

CABLES & CONTROL BOX



Install the 12 volt DC power (4 pin XLR) in rear of Joystick Box.

Note: Any 12 volt battery may operate the PROAIM™ SR PAN TILT HEAD as long as the

connector mates and is #1 pin Negative and #4 pin Positive.

CAUTION: DO NOT USE A UNREGULATED POWER SUPPLY! IF USING A REGULATED POWER SUP-

PLY IT MUST PRODUCE LESS THAN 12 VOLTS. MORE THAN 24 VOLTS MAY CAUSE PERMANENT

DAMAGE.

Table of Contents

Kite-22-starter