Interconnecting Components - Sea Recovery SRC Aqua Matic 450-1 Owner's Manual

Reverse osmosis desalination system
Hide thumbs Also See for SRC Aqua Matic 450-1:
Table of Contents

Advertisement

**If water lines are pulled tight causing them to
bend at the fitting they will leak, allow air to enter,
fail prematurely, and or break the fitting that they
are attached to.**
5.3

INTERCONNECTING COMPONENTS

INTERCONNECTING COMPONENTS WITH SUPPLIED HOSE
1.
Using the supplied 3/4 in. (19 mm) I.D. clear
braided hose connect the Suction Line
components, Low Pressure line components, and
Brine Discharge Line components:
Secure each connection with the supplied
hose clamps. Ensure all Suction Hose connections
use two hose clamps rotated 180 degrees with
the screw heads facing the same direction.
Remove any flash on the Hose Barb fittings
using fine sandpaper.
If your System is not supplied with a mentioned
optional component then skip it and connect to the
next supplied component.
2.
With the supplied 50 feet (15 meters) of 1/2 in.
(12.7 mm) I.D. clear braided hose connect the
Product Water Line components and secure each
connection with the supplied hose clamps, placing
1 hose clamp onto each hose barb fitting:
Component Interconnect Chart
Outlet of
Inlet Connection
Sea Strainer
Rinse Clean Inlet Valve unused left or right port
Rinse Clean Inlet Valve center port
Booster Pump
Prefilter Option
Brine Discharge Tee
Rinse Clean Discharge Valve
Rinse Clean Discharge Valve
Multi Media Filter Waste Line (if used)
pH Neutralizing Filter
Ultra Violet Sterilizer
3.
1/4 in. (6.35 mm) OD nylon tubing is supplied with
applicable components for connecting Pressure
Pick Up points to the Low Pressure Transducers. Use
or non use of the 1/4 in. (6.35 mm) OD nylon tubing is
dependent upon prefiltration options installed.
4.
Ensure all High Pressure Hoses supplied for the
RO Pressure Vessel assembly have sufficient slack
and are not pulled tight into a sharp or immediate
bend. (Refer to fig. 5c)
Figure 5c - Always allow slack in all tube and hose lines.
To Inlet of
Sea Strainer
Rinse Clean Inlet Valve left or right port
Rinse/Clean container
Booster Pump
Prefilteration Options
LP Manifold
Rinse Clean Discharge Valve
Cleaning Bucket
Brine Discharge Connector
Multi Media Filter Discharge Fitting separate
Thru-Hull or Tee at Brine Discharge Connector
Ultra Violet Sterilizer
Potable Water Storage Tank or Cistern
Aqua Matic Modular 450-1800
Page 5-5

Advertisement

Table of Contents
loading

Table of Contents