Sea Recovery SRC Aqua Matic 450-1 Owner's Manual page 131

Aqua Matic Modular 450-1800
loose at one of the connections or the cable
is defective.
h) If there is no voltage present while system
is operating, then troubleshoot the Control
Printed Circuit Board.
30. Charcoal Filter: A sulfurous (rotten eggs) odor
from the product water requires the replacement
of the Charcoal Element. Otherwise, the Charcoal
Element should be replaced every 3 to 4 months. It
is not cleanable.
CAUTION: Do not use third party
charcoal or carbon filter elements;
use only Sea Recovery Charcoal Filter
Elements. Many third party Charcoal
Filter Elements on the market do not
properly fit, the seams fall apart, and they
will allow by-pass.
WARNING: Many third party Charcoal
and Carbon Filter Elements on the market
are designed for a very low flow rate
and will cause extensive and expensive
damage to the Sea Recovery System
resulting from several hundred pounds
of pressure build up on the product water
line. Excessive pressure resulting from
third party Charcoal or Carbon Filter
Elements will damage: R.O. Membrane
Element, Product Water Flow Meter,
3-Way Product Water Diversion Valve,
Charcoal Filter Housing, and the Product
Water Line.
DO NOT ACCEPT THIRD PARTY CHARCOAL FILTER
ELEMENTS FROM ANY MARINE DEALER. USE ONLY SEA
RECOVERY SUPPLIED CHARCOAL FILTER ELEMENTS. The
resulting failure of the system to remain in operation, and
or damage to the Sea Recovery System caused by Third
Party Charcoal or Carbon Filter Elements is attributed to
improper maintenance and operation, is the liability of
the operator and owner, and is not covered by the Sea
Recovery warranty.
To replace the Charcoal Filter Element:
a) Unscrew the bowl counter clockwise.
b) Remove the Charcoal Filter Element from
the bowl.
Page 8-16
c) Remove the O-Ring from the top of the bowl
and take care to not damage it.
d) Replace the Charcoal Filter Element with a
new Sea Recovery element.
e) Wipe the O-Ring with a damp cloth.
f) Sparingly lubricate the O-Ring lightly with
O-Ring lubricant.
g) Place the O-Ring back onto the bowl.
h) Insert the new, Sea Recovery Charcoal Filter
Element into the bowl.
i) Screw the bowl on clockwise.
j) Hand snug to seal the O-Ring, do not use
a wrench or other tool to tighten, do not
over tighten. Over tightening causes stress
to the lid and bowl threads resulting in
damage, breakage, or cracks and subsequent
removal difficult.
31. pH Neutralizing Filter: The pH Neutralizing
cartridge will require replacement when
the calcium carbonate within the cartridge
has dissolved.
To replace the pH Neutralizing Cartridge:
a) Unscrew the bowl counter clockwise.
b) Remove the pH Neutralizing Cartridge
from the bowl.
c) Remove the O-Ring from the top of the bowl
and take care to not damage it.
d) Replace the pH Neutralizing Cartridge with a
new Sea Recovery Cartridge.
e) Wipe the O-Ring with a damp cloth.
f) Sparingly lubricate the O-Ring lightly with
O-Ring lubricant.
g) Place the O-Ring back onto the bowl.
h) Insert the new, Sea Recovery pH Neutralizing
Cartridge into the bowl.
i) Screw the bowl on clockwise.
j) Hand snug to seal the O-Ring, do not use
a wrench or other tool to tighten, do not
over tighten. Over tightening causes stress
to the lid and bowl threads resulting in
damage, breakage, or cracks and subsequent
removal difficult.