Making Cotton Candy; Shutting Down - RoboLabs Monster User Manual

8. Depending on conditions, it will take about one minute to warm
up the head to operating temperature. You will usually smell
the candy aroma between 10 to 15 seconds before production
2
begins.

4.4 Making cotton candy

• Get a stick and put it into the pan and start to collect the cotton
floss onto the stick.
• Pull out the stick out of the pan, spinning the stick with hands
at the same time, pulling the floss out of the pan.
• Keep winding. Once there's enough serving on the stick, tear
the floss flow. That's it!

4.5 Shutting down

• Turn the heating switch (pos.14 Fig.4) OFF.
• Capture remaining cotton candy as the head cools down.
• Let the head spin for 5-7 minutes to cool down before turning
o the main power switch.
• Turn the main power switch (pos.11 Fig.4) OFF.
Once the head is cooled down and motor is stopped, cover the head
with a paper or plastic bag to protect the flossugar from dust, debris
and insects. The machine and Floss Pan should be wiped down with
a damp cloth to remove excess flossugar as needed.
If you are shutting down for longer than one day, then you should
perform a complete cleaning of the spinning head as described in
the Cleaning and maintenance section below. Do not leave unused
flossugar in the spinning head for more than a day or two as it can
harden/caramelize and a ect the balance of the head during future
sessions, which could ultimately result in failure of the machine.
During transportation always secure the chassis using the trans-
portation fastening nuts. This will prevent possible damage of the
machine and prolong its life.
2
When this is the very first time of using the new machine, or the sidewall was re-
cently cleaned, the floss might be rough and sti . As little amount of floss built up on
the sidewall, the output product becomes more soft.
12