C) Fixing the position of the trimmer solenoid (see figure 43)
a) When the whole trimmer shake linkage① is in up position, that is, when it has come back to its original position after
finishing trimming, the distance④ between the lower part of the roller② and the equal point of the trimming cam ③ is
about 0.8~1mm. Assuming that this distance④ never changes, adjust the position of solenoid bracket⑦ horizontally,
where the solenoid housing⑥ is attached, to make the solenoid stroke⑤ 4 mm. Then, tightly fasten with fixing screw⑧.
b) After adjusting the solenoid stroke⑤, manually operate the solenoid shaft ⑨ towards the arrow direction. See
whether it returns to its original position fast and smooth when released. If not, proceed with horizontal adjustment
of the bracket⑦.
(2) Adjustment of linking device for movable knife shaft and the trimmer driving part (see figure 44)
⑮
⑩
⑨
A) When the previously explained adjustment of trimmer driving part is complete, it is in its normal position where the
trimmer shake linkage① has returned to its up position after trimming action.
B) First, loosen the fixing screw② of the movable knife shaft (right), hold the initial assembling angle of the crank (right)
③ to be about 27° to the left from the perpendicular line drawn to its center④. To make sure that this position is
maintained, adjust the length of the ball joint linking bar⑥, and tightly fasten the fixing screw② of the crank (right).
(For the adjustment of the ball joint linking bar⑥, turn the linking bar⑥ after loosening the nuts (left)⑦ and (right)⑧.
Nut (left) is left screw and nut (right) is right screw.)
C) Then, loosen the fixing screw ⑨ of the movable knife shaft crank (left), and in the same angle as the crank(right)'s③
lower assembling angle ⒔, place the crank(left) ⑩. Unfasten the fixing bolt ⑫ and hinge screw⑬ to adjust the length
of the connecting rod ⑭, and then fasten the fixing bolt ⑬ and hinge screw⑫ to make sure this position holds.
D) When the linking device is connected as such, the movement angles ⑮⒃⒔⒕ of crank (left)⑩ and (right)③ during
trimming movement results in an equal angle movements for left and right, against the perpendicular lines⑤ and ⒖
that are drawn from the center line ④ of both sides of the movable knife shafts. Hence, it can be said that the
trimming movement is very light.
E) For KM-857-7, refer only up to the assembling direction down to the movable knife shaft crank (right)③.
①
0.8~1mm
②
④
③
⒖
⑫
⑭
⒃
⑬
④
4mm
⑤
⑥
⑦
⑧
⑤
27。
⒕
⒔
③
②
Solenoid Stroke
⑥
⑧
⑦
①
[Figure 43]
[Figure 44]
29