Wireless General Setup - Cerio PS-200N-AX User Manual

5.6 Wireless General Setup

The administrator can change the data transmission, channel and output power settings for the
system. Please click on Wireless -> General Setup and follow the below setting.
MAC Address : The MAC address of the Wireless interface is displayed here.

Band Mode : Select an appropriate wireless band; bands available are 801.11 a/n mixed

mode or pure a mode or pure n mode
Country : a region, the PS-200N-AX support region for US,ETSI and Japan

TX Power : You can adjust the output power of the system to get the appropriate coverage

for your wireless network. Specify digit numbers between level 1 to level 9 (the unit is %) for
your environment. If you are not sure which setting to choose, then keep the default setting
level 9 (100%).
RF(On/Off) Schedule : The AP RF

HT Physical Mode

Tx/Rx Stream : By default, it's 2

Channel Bandwidth : The "20/40" MHz option is usually best. The other option is

available for special circumstances.
MCS : This parameter represents transmission rate. By default (Auto) the fastest possible

transmission rate will be selected. You have the option of selecting the speed if
necessary.
Signal on/off by time Policy
CERIO software core : cen_v3.0