Table of Contents
Advertisement
Manual – Click the "Connect" button on "WAN Information" in the Overview page
to connect to the Internet.
Idle Time : Time to last before disconnecting PPPoE session when it is idle. Enter
preferred Idle Time in minutes. Default is "0", indicates disabled. When Idle time is
disabled, the "Reconnect Mode" will turn out "Always on"
MTU : By default, it's 1460 bytes. MTU stands for Maximum Transmission Unit.
Consult with WISP for a correct MTU setting.
MPPE Encryption : Microsoft Point-to-Point Encryption (MPPE) encrypts data in
Point-to-Point Protocol(PPP)-based dial-up connections or Point-to-Point Tunneling
Protocol (PPTP) virtual private network (VPN) connections. 128-bit key (strong)
and 40-bit key (standard) MPPE encryption schemes are supported. MPPE
provides data security for the PPTP connection that is between the VPN client and
the VPN server.
DNS : Check "No Default DNS Server" or "Specify DNS Server IP" radial button as
desired to set up system DNS.
Primary : The IP address of the primary DNS server.
Secondary : The IP address of the secondary DNS server.
NAT : The NAT support Enable and Disable Service
MAC Clone : The MAC address is a 12-digit HEX code uniquely assigned to hardware as
identification. Some ISPs require you to register a MAC address in order to access to
Internet. If not, you could use default MAC or clone MAC from a PC.
CERIO software core : cen_v3.0
Advertisement
Table of Contents
