Wireless General Setup - Cerio PS-200N-AX User Manual

Click Save button to save your changes. Click Reboot button to activate your
changes
4.4

Wireless General Setup

The administrator can change the data transmission, channel and output power settings for the
system. Please click on Wireless -> General Setup and follow the below setting.
MAC Address : The MAC address of the Wireless interface is displayed here.

Band Mode : Select an appropriate wireless band; bands available are 801.11 a/n mixed

mode or pure a mode or pure n mode etc.
Country : a region, the PS-200N-AX support region for US,ETSI and Japan

TX Power : You can adjust the output power of the system to get the appropriate coverage

for your wireless network. Specify digit numbers between level 1 to level 9 (the unit is %) for
your environment. If you are not sure which setting to choose, then keep the default setting
level 9 (100%).
RF(On/Off) Schedule : The AP RF Signal on/off by time Policy

HT Physical Mode

Tx/Rx Stream : By default, it's 2

Channel Bandwidth : The "20/40" MHz option is usually best. The other option is

available for special circumstances.
CERIO software core : cen_v3.0