Cerio PS-200N-AX User Manual page 10

Support PoE Bridge by LAN Port function.

Build in lightning arrester (15kV ESD)

Support 8 Multiple-BSSID. And Support IEEE802.11f IAPP

Support Static Routing and RIP and OSPF Dynamic Routing by CPE mode.

Support Layer-7 Protocol Filter and Content Filter by CPE mode.

QoS(Quality of Service) for bandwidth management and traffic prioritization

Support IEEE802.1d Spanning Tree

Integragted IGMP v1/v2/v3 snooping functions and Support Web management and SNMP

MIB-II
Built-in software interface allows for communicating with CERIO AM-Series AP Management

WLAN Switch or Access Controller of network management servers.

Networking by CPE mode.
Support Static IP, Dynamic IP(DHCP Client) and PPPoE on WiFi WAN Connection

Support VPN Pass Throughput ( PPTP , IPSec , L2TP ) and MAC Cloning

Proxy DNS ,Dynamic DNS ,NTP Client

Virtual DMZ, Virtual Server (IP / Port Forwarding) and

Support IP / MAC Filter and Support Bandwidth trafic Shaping

Wireless Feature
Transmission power control : Layer 1~9

Channel selection : Manual or Auto

No of associated clients per AP : 32

Setting for max no associated clients : Yes

Support 8 virtual BSSID and associated clients per AP to 32 and the Pure WDS Max. 8

Setting for transmission speed

Dynamic Wireless re-transmission

IEEE 802.11i Preauth (PMKSA Cache )

IEEE 802.11h - TPC(Transmission Power Control)

IEEE 802.11d -Multi country roaming

Channel Bandwidth setting : 20MHz or 20/40MHz

HT Tx/Rx Stream selection : 1 or 2

Short Slot support

Authentication/Encryption (Wireless Security)
Blocks client to client discovery within a specified VLAN

WEP 64/128 bit /EAP-TLS + Dynamic WEP , EAP-TTLS + Dynamic WEP

PEAP/MSPEAP + Dynamic WEP

WPA-PSK/TKIP,WPA-802.1x/TKIP, 802.11i WPA2-PSK/CCMP/AES 128/256bit,

WPA2 (802.1x /CCMP / AES 128/256bit ), No. of registered RADIUS servers : 1

CERIO software core : cen_v3.0