Quick Installation Guide; Connect Pc And O2Imd1 To Network; Install Speco-Nvr And Set Ip Parameters On O2Imd1 - Speco Intensifier IP O2iMD1 User Manual

O 2 i M D 1 U s e r ' s G u i d
O 2 i M D 1 U s e r ' s G u i d

4.2. Quick Installation Guide

4.2.1. Connect PC and O2iMD1 to network.

1. Prepare a PC to run programs for the installation and video connection Prepare a PC to run programs for the installation and video connection
(PC is needed to assign IP address to (PC is needed to assign IP address to O2iMD1)
2. In the case of using PoE, connect the PC and
If your LAN Switch does not support standard PoE, connect If your LAN Switch does not support standard PoE, connect O2iMD1 as shown in dotted line in Figure
The DC power is applied through DC adapter. The DC power is applied through DC adapter.
4.2.2. Install Speco-NVR and set IP parameters on
Speco-NVR is a multi-channel VMS program for the IP camera. Install Speco
connect to these products. It is needed to assign connection information to Speco e products. It is needed to assign connection information to Speco-NVR program before
connection. Insert the CD provided with product into the PC and install Speco connection. Insert the CD provided with product into the PC and install Speco-NVR.
e
e
to network.
, connect the PC and O2iMD1 to the network using one of the following ways.
LAN switch
LAN switch with
standard POE
Figure 4-1. Power and network connection Figure 4
and set IP parameters on O2iMD1
channel VMS program for the IP camera. Install Speco-NVR on remote PC to
Figure 4-2. Speco-NVR
to the network using one of the following ways.
DC adaptor
(802.3af)
ONSIP Installer
shown in dotted line in Figure.
NVR on remote PC to
NVR program before
Admin Page Button Admin Page Button