Advertisement
3.2 ADJUSTING THE LEVELLING LEGS
This cooker stands on 4 levelling legs. As the legs are initially on a lower position, you
must adjust them to make sure the cooker is balanced before using it. If you need to
balance the cooker, the legs can be adjusted by turning them clockwise. You can
raise the cooker by a maximum of 15mm with the levelling legs. If you have had to
adjust the cooker with the levelling legs make sure to move the cooker by lifting it
rather than dragging it. The levelling leg can be adjusted by hand or a suitable size
coin.
3.3 ELECTRIC CONNECTION AND SAFETY
When it comes to connecting you appliance, please follow the instructions below
carefully.
- Before carrying out the electrical connection, make sure that the current carrying
capacity of your mains electricity supply and your socket is suitable for the maximum
power rating of the cooker.
- Before proceeding with the electrical connection, verify that the current carrying capacity
of the system and the socket is adequate for the maximum power rating of the oven.
- Electrical installation of the residence and the electrical current plug in use must be
earthed and conform to safety regulations.
- A circuit breaker with a contact opening of at least 3 mm must be installed inside the
supply circuit.
- Do not use adaptors, multiple sockets and/or extension leads.
- Fused switch must be accessible once the oven has been installed.
IMPORTANT: The following diameters of the supply cables must be used in the
case of a one phase connection:
Rated power on
nameplate:
5000W -8700W
at 220V:
5000W -9100W
at 230V:
5000W -9500W
at 240V:
Diameter of supply
cable:
2
3 x 2.5 mm
2
3 x 2.5 mm
2
3 x 2.5 mm
Rated power on
nameplate:
> 8700W at 220 V
> 9100W at 230 V
> 9500W at 240 V
9
Diameter of supply
cable:
2
3 x 4.0 mm
2
3 x 4.0 mm
2
3 x 4.0 mm
Advertisement
