Installation - ADC HiGain H2TU-C-202 User Manual

Installation

I
NSTALLATION
When installing an H2TU-C in a chassis, be sure to wear an antistatic wrist strap. Avoid touching
components on the circuit board.
To comply with the intrabuilding wiring requirements of GR-1089 CORE, Section 4.5.9, the
shields of the ABAM-type cables that connect the H2TU-C DSX-1 output ports to the
cross-connect panel must be grounded at both ends.
1 Align the H2TU-C with the enclosure slot guides, then push the unit in until it touches the backplane
card-edge connector (see
2 Place your thumbs on the H2TU-C front panel and push the H2TU-C firmly into the slot guides until the unit
clicks into the backplane and is properly seated.
6
H2TU-C-202
H0005-A
Figure 3. H2TU-C Installation
Figure 3).
June 6, 2003
LTPH-UM-1208-01
CO Shelf
H2TU-C-202 List 7G