LOGICDATA COSMO Austin Owner's Manual page 22

FACTORY RESET
sitions you have stored will be deleted and replaced with the pre-set memory positions. To per-
form a Factory Reset:
To perform a Reference Drive after the Factory Reset, only release one of the DOWN buttons.
This will start the Drive automatically.
MOVING THE BED FRAME TO A SAVED MEMORY POSITION
Proceed as follows to move the Bed Frame to a saved Memory Position:
MOVING THE BED FRAME TO THE SLEEPING POSITION
The Sleeping Position is the Bed Frame's lowest position. While in the Sleeping Position, all
Platforms are horizontal. Proceed as follows to move the Bed Frame to the Sleeping Position:
ACTIVATING THE CHILD LOCK
Always activate the Child Lock when children are near the Bed Frame. Proceed as follows:
To disable Child Lock, repeat the steps above.
If you remove the batteries from the Remote Control, the Child Lock will be deactivated
automatically.
6 times.
22 //ADJUSTABLE BED FRAME - OWNER'S MANUAL
1. Press and hold the Foot DOWN and Head DOWN buttons for 10 seconds.
2. When the reset is complete, the Control Box will click twice.
3. Release the buttons.
1. Press the Memory Position Button for the Memory Position you wish to
move to, then release.
2. Wait for the Bed Frame to move to the saved Memory Position
3.
1. Press and release the Sleeping Position Button (do not hold the Button)
2. Wait for the Bed Frame to move to the Sleeping Position
1. Press and hold the Head UP and Foot UP Buttons for at least 6 seconds.
2.
Child Lock has been activated.
-