LOGICDATA COSMO Austin Owner's Manual page 21

PAIRING THE REMOTE CONTROL
You must pair the Bed Frame to a Remote Control before operation. Ensure the Bed Frame has
been unplugged for at least 10 seconds, then proceed as follows:
1. Plug the Bed Frame into the mains. This will automatically switch it to Pairing Mode for 30
minutes. In this time, the Bed Frame will search for Remote Controls to be paired with.
2. During Pairing Mode, press and release any Button. This will pair the Remote Control to
the Bed Frame.
UNPAIRING THE REMOTE CONTROL
1. Press and hold the Head UP and Foot DOWN Buttons for at least 10 seconds.
2.
3. Test the Remote Control to check that it has been safely unpaired.
REFERENCE DRIVE
1. Press and hold the Head UP/DOWN, Foot UP/DOWN or Sleeping Position Button. The
lower part of the Bed Frame will begin the reference drive. It will reach a lower limit and
then move up slightly. Do not release the button.
2. Continuing to hold the button, wait for the upper part of the frame to complete the drive.
3. Release the button and use the Bed Frame according to the instructions.
If the drive is interrupted, pressing any movement button restarts downward movement.
MOVING THE BED FRAME UP AND DOWN
1. Press and hold the UP or DOWN Button for the Platform you wish to adjust
2. Wait until the Bed Frame has reached the desired position
3. Release the UP or DOWN Button
The Bed Frame will move until the Button is released or the highest / lowest position is reached.
SAVING A MEMORY POSITION
There are two pre-saved Memory Positions: Anti-Snore (Position 1) and Zero Gravity (Position
2). Press the Memory Position Buttons on the Remote Control to move to these positions. You
can change saved Memory Positions to new Memory Positions. To do this, proceed as follows:
1. Press and hold the UP or DOWN Button for the Platform you wish to adjust
2. Wait until the Bed Frame has reached the desired position
3. Release the UP or DOWN Button
4. Press and hold the Button for the new Memory Position for at least 3 seconds
5. Release the Memory Position Button.
ADJUSTABLE BED FRAME - OWNER'S MANUAL // 21