Setting The Sms Time Zone - B35; Configuring Device Parameters By Meitrack Manager - MeiTrack TC68L User Manual

MEITRACK TC68L/TC68SL Plug-and-Play Vehicle GPS Tracker User Guide
Description:
The device equipped with an OBD II plug is always powered on by the vehicle's battery. You are advised to enable
the sleep function of the device to save battery power.
Sleep level = 0: The sleep mode is disabled (default).
Sleep level = 1: The device enters the normal sleep mode. The GPS module works for five minutes, then the device
will stop working for five minutes. The above actions will be cycled, but the GSM module always works. GPRS and
SMS scheduling functions are not affected.
Sleep level = 2: The device enters the deep sleep mode. If no event (such as the SOS, button triggered, incoming
calls, vibration, or SMS messages) is triggered after five minutes, the GPS module will stop working and the GSM
module will enter the sleep mode. Once an event is triggered, the GPS and GSM modules will be woken up. Then
the above actions will be cycled.
In any condition, you can disable the sleep mode, and then the device exits the sleep mode and returns to the
normal working mode.
In the deep sleep mode, if you want to obtain the location by the SMS or call, when the GPS is valid, the device will
reply to a GPS map link; when the GPS is invalid, it will reply to the most recent GPS map link.
After the device enters the deep sleep mode, functions of Tracking By Time Interval, Tracking By Distance, and
GPSLog are not available until the device is woken up from the deep sleep mode.
The device can be woken up from the sleep mode by pressing a button, making a call, or sending an SMS message.
After events are handled, the device will enter the sleep mode again.
Example:
SMS sending: 0000,A73,2
SMS reply: 353358017784062,A73,OK
5.3.3 Setting the SMS Time Zone – B35
SMS sending: 0000,B35,SMS minute
SMS reply: IMEI,B35,OK
Description:
The default time zone of the device is GMT 0 (480 minutes). This command is used to change the time zone of SMS
reports to the local time zone. The time zone of SMS reports is different from that of GPRS data packets. In addition,
the GPS Log time zone is GMT 0.
SMS minute = 0: The time zone is GMT 0.
SMS minute = [-32768...32767], set time zones. Set the China time zone value to 480.
Example:
SMS sending: 0000,B35,480
SMS reply: 353358017784062,B35,OK (set the Beijing time zone)
For details about SMS commands, see the MEITRACK SMS Protocol.

5.4 Configuring Device Parameters by Meitrack Manager

This section describes how to use Meitrack Manager to configure the device on a computer. For details about
Meitrack Manager, see the MEITRACK Manager User Guide.
Operation steps:
1. Install the USB driver and Meitrack Manager.
2. Connect the device to a computer by using the USB cable.
3. Run Meitrack Manager, then the following dialog box will appear:
4. Turn on the device, then Meitrack Manager will automatically detect the device model and the parameter page
Copyright © 2019 Meitrack Group All rights reserved.
- 12 -