Sms Time Zone - B35; Configured By Computer - MeiTrack MT90 User Manual

Table of Contents

MEITRACK MT90 User Guide

In deep sleep mode, if you want to obtain the location by SMS/call and the GPS is invalid within five minutes, the device will

reply an SMS with a map link instead of location information.

After the device enters deep sleep mode, functions of Track By Time Interval, Track By Distance, and GPSLog are not available

until you manually disable the sleep mode.

The device can be woken up from the sleep mode by pressing a key, call, or SMS. After an event is handled, the device will

enter sleep mode again.

Example: 0000,A73,2

Reply: 353358017784062,A73,OK

7.5 SMS Time Zone – B35

This command is used to change the SMS report time zone. The default time zone of the tracker is GMT 0.

To change the time zone, follow the following instructions:



SMS text:

0000,B35,SMS minute

Send the text to the embedded SIM card phone number.



The MT90 automatically replies to the SMS: IMEI,B35,OK. It indicates that the time zone is set successfully.

Note: The time zone is in unit of minutes. The default time zone of the tracker is GMT 0, and the time zone of SMS reports is

different from that of GPRS data packets. The GPS Log time zone is GMT 0.

When SMS minute is 0, the time zone is GMT 0 (default time zone).

When SMS minute is a value ranging from -32768 to 32767, set time zones. Set the China time zone value to 480.

Example: 0000,B35,480

Reply: 353358017784062,B35,OK (The time zone is set to Beijing time successfully.)

The digit is your MT90's IMEI number.

This section describes how to use Meitrack Manager to configure the MT90 on a computer.

Procedure:

Install the USB-to-serial cable driver and Meitrack Manager.

Connect the MT90 to a PC with the USB-to-serial cable.

Run Meitrack Manager, then the following dialog box will appear:

- 13 -

Table of Contents