Table of Contents
Advertisement
NetVanta 340 Series Hardware Installation Guide
Wall Mounting
Step
1
Decide on a location for the NetVanta 340. Keep in mind that the unit needs to be mounted at or
below eye-level so that the LEDs are viewable.
2
Prepare the mounting surface by attaching a board (typically plywood, 3/ 4" to 1" thick) to a wall
stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
3
Install two #8 PAN headscrews (1 1/ 2" or greater in length) wood screws into the mounted
board, following these guidelines and referring to Figure 3:
•
Screws should be spaced horizontally, approximately 5 inches apart. Find exact positioning
by using the location of the two eyed insets on the bottom of the NetVanta 340 as a guide.
•
Screws should be horizontally level with each other.
•
Leave approximately 1/4 inch of the screws protruding from the board to allow the heads of
the screws to slide into place in the unit's keyed insets.
4
Slide the keyed insets on the bottom of the NetVanta 340 chassis securely onto the screws.
5
Proceed to the steps given in Getting Started on page 24.
61200422L1-34A
Instructions for Wall Mounting
Figure 3. Wall Mounting the NetVanta 340
© 2004 ADTRAN, Inc.
Action
Unit Installation
23
Advertisement
Table of Contents
