Figure 28. Repositioning The Mounting Bracket For Wall Mounting The Netvanta 3205/Netvanta 3305 - ADTRAN NetVanta 3000 Series Hardware Installation Manual

NetVanta 3000 Series Hardware Installation Guide
NetVanta 3205 and NetVanta 3305
Instructions for Wall Mounting NetVanta 3205/NetVanta 3305
Step
1
Remove the mounting ears. Rotate them 90
mounting holes is flush with the bottom of the chassis, and reattach them to the chassis (see
Figure 28).
2 Decide on a location for the unit. Keep in mind that the unit needs to be mounted at or below
eye level so that the LEDs are viewable. Important! Mount the chassis with LEDs facing to the
side as shown in Figure 28 (not facing up or down).
3 Prepare the mounting surface by attaching a board (typically plywood, 3/ 4-inch to 1-inch
thick) to a wall stud. Important! Mounting to a stud ensures stability. Using sheetrock anchors
may not provide sufficient long-term stability.
4 Have an assistant hold the unit in position as you install two #6 to #10 (1 1/ 2-inch or greater in
length) wood screws through the unit's brackets and into the mounted board. See Figure 28.
5 Proceed to the steps given in Supplying Power to the Unit on page 66.
To avoid damaging unit, use only the screws included in shipment when attaching
mounting ears to the chassis.

Figure 28. Repositioning the Mounting Bracket for Wall Mounting the NetVanta 3205/NetVanta 3305

61200860L1-34L
Action
o
so that the portion of the bracket with the
Copyright © 2006 ADTRAN, Inc.
Unit Installation
65