Camera Link® Connector - Mitsubishi Electric KD Series User Manual

3-3 Connections
3-3-3 Camera Link® Connector
* Prepare mini Camera Link® connector
for connecting to this product .
D1
D2
item No.
D1
D2
Camera Link® Cable
D3
connection
D4
◎ : Master port
D5
D6
TM-XG537C
【 Camera Link® Cable connection 】
* Cable is not in product package.
Prepare it by yourself.
1) Camera Link® Cables are connected
2) In the case of Base Configuration
3) 12226-1150-00PL （ by 3M : based on Camera Link® ） is
4) Please use the cable that is based on Camera Link®
Specification. Recommended cable is below.
Product type
A3 A1 A0
◎ ◎ ◎
※ please read and receive the remarks on P.48 and decide
○ ○ ○
× ○ ○
5) Pin assignment is based on Camera Link® Specification.
× ○ ○
6) Master port which is received external synchronized
× × ○
signal and communicates with Frame Grabber by the
× × ○
UART is D1 (common).
Camera Link® is a registered trademark of AIA(Automated Imaging Association)
COPYRIGHT © 2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
Be sure to check connection interface (connector joint, wire diameter)
with D1, D2, D3, D4, D5, D6
one , 2 , 3 cables are necessary
each for A3- type , A1-type and A0-type CIS .
In the case of Medium Configuration
2 , 4 , 6 cables are necessary
each for A3- type , A1-type and A0-type CIS .
recommended .
・ CL-S-SS-020 (Oki Electric Cable Co., Ltd.)
・ DTCL-26P02MM (Daitron Co., Ltd.)
Camera Link® cable.
before using the product.
49