Test Pattern - Mitsubishi Electric KD Series User Manual

5-2 Setting ⑫ Test pattern

5-2-14 Test pattern

【 Input 】 【 Output 】
Command Parameter CR Result Parameter
TP ** CR
[initial]
Test Pattern : Off (normal images output)
Test pattern :
Ramp pattern on main scan direction)
4digit steps
[setting]
Test pattern output
Images
Ramp pattern
Pixel (main direction)
Example
Switch test pattern output turn on
TP 01 <CR> ⇒ 00 01 <CR>
TM-XG537C
CR
** ** CR
On/Off
COPYRIGHT © 2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
【 Test pattern 】
[Function]
CIS output fixed test pattern data instead of Image data to
Camera Link® connector .
By using this test pattern ,it is easy to check the bus line of
image data.
【 Remarks 】
1) This function is for checking the bus line of image data .
2) Image data from sensor ICs is not available during the
test pattern mode is on .
3) When using Test pattern, set each parameters off of
Dark correction, White correction, y correction, PGA
correction.
Camera Link® is a registered trademark of AIA(Automated Imaging Association)
74