Mitsubishi Electric KD Series User Manual page 44

3-1 Dimensions
3-1-3 Side view
1 st -side
A guide hole
Φ3 H9 Depth 6
End-side
Interface
（ 4-M3 × 8)
A guide hole
Depth 6
TM-XG537C
【 Remark 】 How to install CIS into your device
1) Attach CIS to your system at the both end sides of CIS
by M3 screws . Focal point is defined the position from
the guide holes at the end of CIS .
2) There is the focal point of CIS with illumination at
52.0mm and without illumination at 51.4mm form the
guide holes .
Interface
3) For a reference , CIS with illumination the gap is
（ 4-M3 × 8)
located at 12+/-1 mm from glass surface .
4) There are 4screw holes(M3) each end side of CIS (total
8 screw holes). Use guide holes to make sure the CIS
is on the right position.
A guide hole
Depth 6 5) A chassis of CIS is made from aluminum. When
tightening a screw, be careful about thread damage of
screw hole.
6) Shorter than 5.5mm is recommended for a length of the
pin for guide holes.
A guide hole
Φ3 H9 Depth 6
COPYRIGHT © 2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
Material of screw
Tightening force [N ・ cm]
Iron （ strength ranking 4.6)
Stainless (SUS 304)
Brass (C3601BD)
A pin length is
shorter than 5.5mm
72 ± 7
63 ± 6
42 ± 4
Cross section B
44