Jolly A-5 Spot User Manual page 6

Never let the power-cord come into contact with other cables! Handle the power cord and all connections
with particular caution!
Make sure that the available voltage is not higher than stated on the rearpanel.
Always plug in the power plug least. Make suer that the power-switch is set to off-position before you con
ections with themains with particular caution!
Make sure that the power-cord is never crimped or damaged by sharp edges.Check the decice and the p-
ower-cord from time to time.
Always disconnect from the mains, when the device is not in use or before cleaning it.
Only handle the power-cord by the plug,Never pull out the plug by tugging the powercord.
This device falls under protection class I.Therefore it is essential to connect the yellow/green conductor
to earth.
The electric connection,repairs and servicing must be carried out by a qualified employee.
Do not connect this device to a dimmer pack.
Do not switch the fixture on and off in short intervals as this would reduce the lamp's life.
Do not touch the device's housing bare hands during its operation(housing becomes hot)!
For replacement use lamps and fuses of same type and rating only.
Eye damage!
Avoid looking directly into the light source(meant especially for epileptics)!
Minimum distance of illuminated objects
The projector needs to be positioned so that the objects hit by the beam of light are at least
0.8
0.8 metres from the lens of the projector.
Maximum ambient temperature
° C
Do not operate the fixture if the ambient temperatuer(Ta) exceeds 45° C (113° F).
t 45
a
Temperature of the external surface
The maximum temperature that can be reached on the external surface of the fitting,in a ther-
° C
t 90
mally steadystate,is 90° C (194° F).
c
IP20 protection rating
The fitting is protected against penetration by solid of over 12mm (0.47" ) in diameter (first
digit 2), but not against dripping water,rain,splashes or jets of water (second digit 0).
IP20
Indoor use only
Not suitable for household illumination
Photobiological Safety
CAUTION. Do not look directly at the light source.Do not look at the light beam with optical de-
vices or any other tool that could cause light convergence.
The fixture must be positioned so that the minimum distance between the front lens and human
Risk Group 1
According to
eye is at least 3metres to prevent personal photobiological risks.
En62471
Mounting surfaces
F
It is permissible to mount the fitting on normally flammable surfaces.
The products to which this manual refers comply with the European Directives purs-
uant to:
•Safety of electrical equipment supplied at low voltage ( LVD)
EN 60598-1:2015
EN 60598-2-17:1989+A2:1991
•Electromagnetic Compatibility (EMC)
EN55015:2013/A1:2015
EN 61000-3-2:2014
EN 61000-3-3:2013
EN61547:2019
•Restriction of the use of certain hazardous substances (RoHS)
2011/65/EU
- 2 -