Installation - Rational iCombi Pro 6 half size Original Installation Manual

4 | Installation

7 Drain valve bracket
8 Drain pipe
9 Connection pipe
10 Double socket
11 Silicon seal double socket
12 Pipe holder rear wall
13 Silicon seal HT pipe
14 Bracket for drain valve
15 Copper seal
16 Drip pan with pipe
17 Plug for cooking cabinet, with fixing
and chain
18 Screw connection with funnel open-
ing
19 Drain fitting
4 Installation
4.1 Preparing the stand
Stand with rear wall:
Break out the perforation for the plate on
the rear wall of the stand [
Stand without rear wall [
1. Hook the retaining plate on the rear
side of the stand on the table edge.
2. Tighten the 2 screws on the retaining
plate.
4.2 Installing the integrated fat drain
Mounting the drain valve and drain pipes
1. Seal the threads of the two pipe pieces
for the drain valve with teflon tape
[ Figure 04].
2. Mount the two parts of the holder on
the drain valve with the tube angle and
the connecting pipe [
3. Turn the tube angle so that it is
mounted at a 90° angle to the holder.
80.51.389_iCombiPro-iCombiClassic_IFA-TG_IM_US-nord
4. Mount the pipe seal on the pipe socket
5. Join the pipes on the rear wall of the
6. Guide the piping into the stand
7. Push the drain valve into the top rail of
8. Push the piping into the pipe sleeve of
9. Tighten the clamp screws on the drain
10. Place the front fat collection canister in
11. Insert the drain pipe in the front fat
Figure 02].
Figure 03]:
12. Turn the drain pipe so that the pin
13. Push the fat collection tray into the
14. Guide the piping in the cooking cabi-
Opening/closing the funnel
1. Leave the funnel in the cooking cabinet
Figure 05].
>>
in the rear wall of the device
[ Figure 06].
device [ Figure 07].
[ Figure 08].
the stand [ Figure
the drain valve [
valve holder [ Figure
front of the stand and the rear fat col-
lection canister in the stand
[ Figure 12]. The rear canister must
be positioned in the stand so that the
front fat collection canister can be
placed in front of it after further pre-
liminary work.
collection canister and in the tube an-
gle [ Figure 13].
locks in the tube angle [
bottom slot of the device
[ Figure 15].
net into the fat collection tray
[ Figure 16]. Fix the plugs on the
funnel in the cooking cabinet.
open when using the integrated fat
drain.
The integrated fat drain is mounted on
the device.
en-US
09].
Figure 10].
11].
Figure 14].
5 / 16