Pre-Installation Module Programming Test - Directed Directechs DB3 Installation Manual

Pre-Installation Module Programming Test

This Firmware requires the vehicles "8-Channel Gateway" to be Enabled. Before proceeding with the complete install, it is recommended that the following test is performed.
If the test programming is unsuccessful, you must have the gateway enabled by the Nissan dealer.
To test your module, make the connections as shown on the wiring diagram below. When the connections are done, refer to the following section to program your module.
BCM
(behind
dash fuse box)
Module Programming Test
Ensure vehicle is in a safe location and cannot move forward during programming. For vehicles
1
equipped with a manual transmission, make sure the gearshift is in the neutral position.
Connect the 14-pin harness.
2
When the LED turns ON solid red, proceed with the next step.
Press the Push-to-Start (PTS) button once (1) to turn the ignition on.
3
The LED quickly flashes orange and turn green for one second, then slowly flashe orange.
If the LED slowly flashes orange, you can proceed with a full installation as your vehicle does not require scan tool modifications from the
Nissan dealer. However, if the LED flashes red 3 times, you must visit the Nissan dealer and have them enable the "8-Channel Gateway."
Please refer to the "Activating 8-Channel Gateway" section for additional details.
Note: If you are unable to have the vehicle return to the dealership, or they are unwilling to make the changes, you may use the
NISSRS01 Firmware (see installation guide for more details).
6 403.NISS14 1.04 2022 Mitsubishi Outlander (Smart Key)
©2022 VOXX•DEI LLC. All rights reserved.
(-) Ground: HS CAN 2 High:
Blue, pin 6
Black, pin 4
OBDII
1 8
Diagnostic
(black conn.)
9 16
HS CAN 2 Low:
White, pin 14
(+) 12V: Green, pin 16
HS CAN High: Lavender/Blue, pin 26
HS CAN Low: Lavender/Pink, pin 27
20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1
40 39 38 37 36 35 34 33 32 31 30 29 28 27 26 25 24 23 22 21
HS CAN High: Tan/Black: 3
HS CAN Low: Tan: 4
HS CAN 2 High: Orange/Green: 5
HS CAN 2 Low: Orange/Brown: 6
(+) 12V Input: Red: 13
(-) Ground: Black: 14
All connections
are mandatory.
BCM
(gray conn. behind
dash fusebox)
Solid
Connect