Advertisement
Warning: Do not install this equipment in
a confined space such as a bookcase or
similar unit.
Warning: Wiring methods shall be in
accordance with the National Electric Code,
ANSI/NFPA 70.
Warning: This is a class A product. In a
domestic environment this product may
cause radio interference in which case the
user may be required to take adequate measures.
Warning: To reduce a risk of fire or electric
shock, do not expose the internal apparatus
to rain or moisture
Warning: Please adopt the power adapter
which can meet the safety extra low voltage
(SELV) standard. And source with DC 12 V or
AC 24 V (depending on models) according
to the IEC60950-1 and Limited Power Source
standard.
Warning: Install the camera on a ceiling or
wall where can withstand the weight of 5
times of the camera including mounting
bracket.
Caution: This installation shall be made by a
qualified service person and shall conform to
all local codes.
Caution: To avoid electrical shock, do not
open the cabinet. Refer servicing to qualified
personnel only.
Caution: The internal apparatus shall not be
exposed to water (dripping or splashing) and
no objects filled with liquids, such as vases,
shall be placed within the enclosure
Caution: Make sure the power supply voltage
is correct before using the camera.
Caution: Do not drop the camera or subject it
to physical shock.
Caution: The sensor may be burned out by a
laser beam, so when any laser equipment is
being used, make sure that the surface of the
sensor not be exposed to the laser beam.
Caution: While shipping, the camera should
be packed in its original packing.
Note:
Please make sure the product is installed
appropriate places where secured from
flood, such as under the eaves, to operate
properly. This product is certified as IP66
standard. However, if there is any flood
concerns, it is highly recommended to use
an outdoor Housing. When you install the
camera inside an outdoor Housing, please
use one of the following methods:
1.
Remove the front glass of Housing
before installing the camera.
2.
To keep the front glass of Housing,
remove the front cover, and then put
the camera close to the front glass.
To disconnect power from mains, pull
out the mains cord plug. When installing
the product, ensure that the plug is easily
accessible.
Important Safety
Instructions
1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Do not use this apparatus near water.
6.
Clean only with dry cloth.
7.
Do not block any ventilation openings.
Install in accordance with the
manufacturer's instructions.
8.
Do not install near any heat sources
such as radiators, heat registers, stoves,
or other apparatus (including amplifiers)
that produce heat.
9.
Do not defeat the safety purpose of
the polarized or grounding-type plug.
A polarized plug has two blades with
one wider than the other. A grounding
type plug has two blades and a third
grounding prong. The wide blade or the
third prong are provided for your safety.
If the provided plug does not fit into
your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being
walked on or pinched particularly
at plugs, convenience receptacles, and
CAUTION
the point where they exit from the apparatus.
RISK OF ELECTRIC SHOCK
11. Only use attachments/accessories
DO NOT OPEN
specified by the manufacturer .
12. Use only with the cart, stand, tripod, bracket,
or table specified by the manufacturer, or
sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus
combination to avoid injury from tip-over .
13. Unplug this apparatus during lightning
storms or when unused for long periods
of time .
14. Refer all servicing to qualified service
personnel.
Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled
or objects have fallen into the apparatus,
the apparatus has been exposed to rain
or moisture, does not operate normally,
or has been dropped.
Handling of the unit
Be careful not to spill water or other liquids in the
unit. Be cautious not to get combustible or
metallic material inside the body. If used with
foreign matter inside, the camera is liable to fail or to
get cause of fire or electric shock.
•
Remove dust or dirt on the surface of the
lens with a blower.
•
Use a soft and lint-free, dry cloth(such as
glass
cleaner) to clean the body. If it is
very dirty, use a cloth dampened with a
small quantity of neutral detergent then
wipe dry.
•
Avoid the use of volatile solvents such
as thinners, alcohol, benzene and
insecticides.
They may damage the surface finish and/
or impair the operation of the camera.
•
This camera is designed for mounting
on the ceiling or wall. If you install this
camera upside down, it may cause
malfunction.
Operating and storage
location
Avoid viewing a very bright object (such as
light fittings) during an extended period. Avoid
operating or storing the unit in the following
locations.
•
Extremely hot or cold places (operating
temperature 14 ℉ to 122 ℉ , however, we
recommend that the unit be used within
a temperature range of 32 ℉ to 113 ℉ )
•
Damp or dust place
•
Places exposed to rain
•
Places subject to strong vibration
•
Close to generators of powerful
electromagnetic radiation such as radio
or TV transmitters.
•
Do not use the camera in such place
where rapid temperature fluctuation by
switching an air conditioner on and off.
Advertisement
