15Xxx02 Decoding Laser Scanner - Intermec Sabre 1514 User Manual

15XXX02 Decoding Laser Scanner

The 15XXX02 is designed to interface with terminals equipped
with RS-232 serial communication ports. The interface cable
used with the terminal has a modular plug that resembles a
telephone connector and a D-type connector for the terminal
serial port.
To connect the 15XXX02 scanner
1. Connect the modular plug on the interface cable to the
bottom of the scanner handle. The 1551 models have a screw
to tighten that secures the plug in the handle.
2. Make sure the terminal is turned off. Then connect the
D-type connector end of the cable to the serial port.
3. Connect the external power supply cable to the side of the
D-type connector.
4. Plug the external power supply into an outlet or surge
protector.
5. Turn on the power to the terminal.
6. Scan this bar code to set default values:
Reset to Default Values
The scanner is ready to be used as a hand-held scanner and will
send data directly to the terminal. The default symbologies are:
UPC-A
UPC-E (not expanded)
Code 39
Code 128
See Chapter 2 to learn basic scanning operation, scanning tips,
and how to use with the scanner stand for hands-free scanning.
To change the scanner configuration, see Chapter 3.
Connecting the Scanner
ZA
1
1-5