Regulatory Statements - Intermec Sabre 1400 Quick Start Manual

Regulatory statements

Intermec hereby declares that the Sabre 1400 has been tested and found compliant with the below listed standards
as required by the EMC Directive 89/336/EEC as amended by 92/31/EEC and by the Low Voltage Directive 73/23/EEC
as amended by 93/68/EEC: EN55022, EN55024, EN60950, EN 60825-1. This device is TÜV GS certified for safety: EN
60950 and EN 60825-1.
Class 1 LED product - safe when used in any reasonable operating conditions.
USA: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. However, the equipment has also been tested and found to comply with the more
stingent requirements for a Class B device, pursuant to Part 15 of FCC rules.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
In order to maintain compliance with the FCC Rules, the I/O cables that interconnect between the device and any peripheral
must be as specified by Intermec.
Caution: Changes or modifications not expressly approved by Intermec could void the user's authority to operate this equipment.
This device is UL and cUL listed (UL 1950/C22.2 no. 950).
Canada: This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
Cet équipement est listé UL et cUL (UL 1950/C22.2 no. 950).
The information contained in this document is for informational purposes only and is subject to change without notice. No part
of this document may be copied or reproduced in any manner without the prior written permission of Intermec Technologies
Corporation.
Sabre products are covered by patents issued or pending in the USA and other countries.
The word Intermec and the Intermec logo, Sabre are either trademarks or registered trademarks of Intermec.
Throughout this document, trademarked names may be used. Rather than put a trademark (™ or ®) symbol in every occurrence
of a trademarked name, we state that we are using the names only in an editorial fashion, and to the benefit of the trademark
owner, with no intention of infringement.
EasySet® is a registered trademark of Intermec Technologies Corporation.
©2006 Intermec Technologies Corporation
All rights reserved.
14