Regulatory Statements - Intermec ScanPlus 1800 Quick Start Manual

Regulatory statements

Intermec hereby declares that the ScanPlus 1800 has been tested and found compliant with the below listed
standards as required by the EMC Directive 89/6/EEC as amended by 92/1/EEC and 9/68/EEC and by the
Low Voltage Directive 7/2/EEC as amended by 9/68/EEC:
EN022 EN0024
This device is TÜV licensed (EN 6090-1 and EN 6082-1) for safety only when powered by an external Intermec power
supply.
USA: This device complies with Part 1 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 1 of
the FCC Rules. It generates, uses and can radiate radio frequency energy. If not installed and used in accordance with the
instructions, it may cause interference to radio communications. If this equipment causes interference, the user will be
required to correct the interference at the user's own expense.
This equipment complies with the UL 190 and CSA C22.2 standards.
Canada: This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
This equipment complies with the cUL 190 and CSA C22.2 standards.
Cet équipement est conforme à la norme cUL 190 et CSA C22.2.
Australia-New Zealand: This equipment has been tested and found to conform to the Australian
EMC framework concerning Class B digital devices, prescribed by the Australian and New-Zealand
standard AS/NZS 48.
Mexico: Este equipo cumple con la certificatión NOM.
The information contained in this document is for informational purposes only and is subject to change without notice.
No part of this document may be copied or reproduced in any manner without the prior written permission of Intermec
Technologies Corporation.
The word Intermec, the Intermec logo, ScanPlus are either trademarks or registered trademarks of Intermec.
EasySet® is a registered trademark of Intermec Technologies Corporation.
Throughout this document, trademarked names may be used. Rather than put a trademark (™ or ®) symbol in every occur-
rence of a trademarked name, we state that we are using the names only in an editorial fashion, and to the benefit of the
trademark owner, with no intention of infringement.
Class 1 LED product - safe when used in any reasonable operating conditions (ScanPlus 1800 SR, PDF, VT and VTPDF)
© 2006 Intermec Technologies Corporation
All Rights Reserved
EN6090-1 EN6082-1
14
N09
North America / Asia Pacific / Latin America • 6001 6th Avenue West, PO Box 4280, Everett, WA 9820-9280 Tel: +1 42
48 2600 • Fax: +1 42 48 28 • U.S. service and technical support, tel: 1.800.7.0 • Canadian service and technical
support, tel: 1.800.688.704
Eu r o p e / M i d d l e E a s t / Af r i c a • S o v e r e i g n H o u s e , Va s t e r n R o a d , R e a d i n g R G 1 8 B T, E n g l a n d
Tel: +44 118 987 9400 • Fax: +44 118 987 9401
Internet: www.intermec.com
E-mail: info@intermec.com
1