Faber FMG3326F Instruction Manual page 6

WARNING
CARBON MONOXIDE POISONING HAZARD
Failure to follow the steps outlined below for
each appliance connected to the venting system
being placed into operation could result in carbon
monoxide poisoning or death. The following steps
shall be followed for each appliance connected to the
other appliances connected to the venting system
are not in operation:
1. Seal any unused openings in the venting system.
2. Inspect the venting system for proper size and
and these instructions. Determine that there is no
condition.
windows and all doors between the space in which
are located and other spaces of the building.
5. Turn on clothes dryers and any appliance not
connected to the venting system. Turn on any
speed. Do not operate a summer exhaust fan.
6. Follow the lighting instructions. Place the
appliance being inspected into operation.
continuously.
7. Test for spillage from draft hood equipped
appliances at the draft hood relief opening after 5
of a match or candle.
8. If improper venting Is observed during any of
corrected in accordance with National Fuel Gas
9. After it has been determined that each appliance
connected to the venting system properly vents
previous conditions of use.
WARNING
draperies.
Children and adults should be alerted to the hazards
of high surface temperature and should stay away to
avoid burns or clothing ignition.
WARNING
This appliance must be electrically wired and
Code ANSI/NFPA 70-latest edition or the Canadian
Electric Code CSA C22.1. A 110–120 V AC circuit
for this product must be protected with ground-fault
locations such as in bathrooms or near sinks.
WARNING
Young children should be carefully supervised
when they are in the same room as the appliance.
Toddlers, young children and others may be
susceptible to accidental contact burns. A
physical barrier is recommended if there are at
risk individuals in the house. To restrict access to
an appliance or stove, install an adjustable safety
gate to keep toddlers, young children, and other
at risk individuals out of the room and away from
hot surfaces.
Faber requires installation be performed
Faber installer. Installations that do not
follow this instruction will not be covered
by warranty or serviced.
We recommend removing the glass with the suction
cups supplied by the manufacturer. When glass is
is to prevent damage to the glass edges. Extra care
must be taken when removing/installing the glass.
Breakage or damage to the edge of the glass which
occurs as a result of careless handling will not be
covered under warranty.
6