Related Manuals for Concept Pro CVP5325DNIR-IP2M/2.8
Summary of Contents for Concept Pro CVP5325DNIR-IP2M/2.8
- Page 1 CVP5325DNIR-IP2M/2.8 CVP5325DNIR-IP4M/2.8 IP External Compact Dome Camera QUICK START GUIDE Technical Documents IP CAMERA QUICK START GUIDE...
-
Page 2: Installation
1. CONTENTS Packaging Contents IP Camera x1 Fitting Screws x3 Technical Documents Quick Start Guide x1 Wall Plugs x3 Mounting Template x1 Hex key x1 Silica Gel x1 Analogue SVO Cable x1 2. INSTALLATION Important: Ensure all precautionary procedures are observed during installation. It is recommended that the camera is tested in low light and harsh lighting conditions during installation to ensure continuity of effective CCTV monitoring. -
Page 3: Configuring The Camera
3. CONFIGURING THE CAMERA Internal Camera Connections 3 4 5 Item Name Description Control Button Used to change analogue format, restart the camera, and reset the camera to factory default settings. - Change Analogue Format: Press and hold for <5 seconds. - Page 4 This is highly recommended for all users to ensure proper device security. Using the Concept Pro Test Monitor (VLEDTM-TS7) Turn on the VLEDTM-TS7 test monitor and enter the IP Camera menu, then select ONVIF.
-
Page 5: Troubleshooting
5. Troubleshooting Common Issues Answered Can’t find the camera IP address using MDLoad or other software: • Make sure Ethernet and/or DC power cables are correctly connected to the camera. • Make sure the PoE switch or DC power source meets the camera power requirements. If using PoE, make sure the PoE switch is powered on. - Page 6 6. Caution Safety Precautions 1. Carefully read all instructions and warnings prior to using this device. 2. Installation should be made by qualified service personnel and should adhere to all local codes. 3. Do not install this device near water or in excessively humid conditions. 4.
- Page 7 To use video analytics, you must first ensure the license is recognised by the recorder. To do this, first connect the camera to the Concept Pro recorder over the network or through its PoE ports. Then, through the recorder user interface, navigate to <MENU> ➔ <SYSTEM SETUP> ➔ <SYSTEM>...
- Page 8 Deep Learning Video Analytics This camera can also be used with select Concept Pro recorders to provide highly accurate deep learning video analytics, including human, animal, and/or vehicle intrusion detection and illegal parking detection. This level of object classification is far more accurate and intelligent than traditional video analytics and can help focus your system on what is of primary importance.
- Page 9 Increasing Camera Video Stream Bit Rate Navigate to <MENU> - <CAMERA> - <CAMERA SETUP> - <STREAM SETUP> to configure the camera bit rate as desired (up to 8Mbps for first stream, up to 2Mbps for second stream). With Smart Storage Compression (SSC) off by default, the system will record video streams at higher bit rates, and preserve this bit rate no matter the record FPS.
- Page 10 Smart Storage Compression (SSC) SSC on Concept Pro NVRs is designed to limit the camera bit rate according to the recording FPS value. With Smart Storage Compression (SSC) set to ON, the system will reduce the maximum bit rate to 4Mbps for the main stream and 1Mbps for the sub stream. It will also automatically adjust the max bit rate according to the record FPS setting.
- Page 11 8. Dimensions Product Dimension All measurements are in mm. AMI / Mini Indoor Dome Fixed tWDR Day&Night 3D DNR SD Card IP CAMERA QUICK START GUIDE...
Need help?
Do you have a question about the CVP5325DNIR-IP2M/2.8 and is the answer not in the manual?
Questions and answers