SUNSTONE MICRO E User Manual page 11

HEIGHT ADJUSTMENT
Reference Figure 6.1 and follow these instructions to adjust the height of the weld head from its base.
• Loosen the two T-handle knobs (A) on the right side of the unit toward the back.
• Turn the large circular knob (B) at the back of the unit counterclockwise to raise the unit or clockwise to
lower the unit.
• Once the desired height is achieved, re-tighten the two T-handle knobs (A).
CABLE CONNECTIONS
• Remove the 48VDC desktop power supply and 90-250VAC power cord from the packaging.
• See Figure 7.1. Connect the power cord (C) to the desktop power supply (D).
E
Figure 7.1. Connect the included power cord (C) to the desktop power supply (D) and to a wall outlet. Connect the Barrel Jack
Connector (E) to the power supply port on the left side of the weld head labeled "48VDC 2.5A" (F) as shown in Figure 7.2.
• Plug the Barrel Jack Connector (E) of the desktop power supply into the left side panel connector
labeled "48VDC 2.5A" (F) as shown in Figure 7.2.
• Plug the power cord into a wall outlet.
• Remove the RJ12 cable (G) from the packaging. Connect one end to the RJ12 port (H) at top of the weld
head, as shown in Figure 7.3. Plug the other end into the back of your welding power supply in the loca-
tion labeled "Accessory".
F
Figure 7.2. Connect the Barrel Jack
connector (E) to the power supply
port on the left side of the weld
head labeled "48VDC 2.5A" (E).
Figure 7.3. Connect the weld head to
the welder using the RJ12 cable (G).
D C
Questions? Call or Text +1 801-658-0015 • 7
e Micro Welder Experts
G
H