Subscribe to Our Youtube Channel
Related Manuals for SUNSTONE MICRO E
Summary of Contents for SUNSTONE MICRO E
- Page 1 MICRO ™ Supplemental Setup Instructions for Microscope Light Ring The enclosed instructions replace the “LED Lighting” section found on page 15. Version 20211208...
- Page 2 ™ Foreword The original design and specifications for the Sunstone Micro E included optics LED lighting placed below the optics. First generation Micro E units were outfitted with this configuration. However, a secondary design included the use of a light ring with LED lights, as described in this supplement.
- Page 3 e Micro Welder Experts • Next, remove the Light Ring (C) and loosen all three screws (D) so only 1/8” of the screw can be seen inside the Light Ring. See Figure 3. • Position the Light Ring (C) under and then over the Adapter Ring (A) so the screws will hang on a lip found on the outside the Adaptor Ring (A).
- Page 4 MICRO USERS GUIDE ™ 1693 American Way Ste 5 • Payson UT 84651 USA Tel. +1-801-658-0015 wwww.sunstonewelders.com ©2021 Sunstone Engineering LLC. Sunstone and Micro E are trademarks of Sunstone Engineering LLC. 2021208 iv • Questions? Call or Text +1 801-658-0015...
Need help?
Do you have a question about the MICRO E and is the answer not in the manual?
Questions and answers