Intermec EasyCoder PF8 Install Manual page 5

Cutter

Hide thumbs Also See for EasyCoder PF8:

Table of Contents

Plug the electrical connector into the main board.

Note: There are two sockets on the main board, one is for the

stripper and the other is for the cutter. Check the pin

configuration of the socket before plugging in the connector.

Close the bottom case cover. Your printer is now able to print on media

for cut-off operation. Refer to the PF8d/PF8t User's Guide

(P/N 934-011-xxx) for instructions on loading media for cut-off

operation.

Table of Contents

Need help?

Do you have a question about the EasyCoder PF8 and is the answer not in the manual?