Henny Penny Velocity PXE 100 Kit Instructions page 2

Procedure
Assemble Selector Valve
NOTE: Build the selector valve subassembly for later use in the instructions.
1. Attach x1) FP01-232 - FITTING-90 ¾-16 SAE TO 7/8-1 and x1) FP01-312 - EXTEND-10 SAE MORB TO 10
FORB to Port 0 of selector valve and tighten snug as shown.
2. Attach x2) FP01-311 - EXTEND-8 SAE MORB TO 8 FORB to Ports 1 and 2 and tighten snug.
3. Attach x2) FP01-313 - EXTEND-8 SAE MORB TO 8 45 FLARE to port 1 and 2 fitting oriented toward far
end of selector valve and tighten port 1 fitting snug. DO NOT TIGHTEN PORT 2 FITTING.
NOTE: Oil all O-rings and associated parts.
4. Attach x1) 159513 - BRACKET-SELECT V REAR MTG oriented as shown using x1) SC01-057 - SCREW 1/4-
20 X 1/2 HEX HD C with MS01-528 - LOCTITE THREAD- LOCK #242 (Blue).
5. Attach x1) 159501 - WELD ASSY-SELECTOR V MTG BRKT to selector valve oriented as shown using x3)
SC01-057 - SCREW 1/4-20 X 1/2 HEX HD C with MS01-528 - LOCTITE THREAD- LOCK #242 (Blue).
Assemble the Plumbing
6. Attach x1) FP01-280 - FTG-SAE 12, SAE 12 FLARELESS to intake end of x1) 90506-001 - VALVE-CHECK
SAE 12-3PSI.
7. Attach x1) FP01-281 - FTG-SAE 12 TO 3/4 NPT to output end of Check Valve.
8. Apply MS01-749 - LOCTITE PIPE SEALANT to the output end of the check valve fitting and attach to the
end of x1) FP01-097 - TEE-3/4 NPT FEMALE PIPE BI.
9. Apply MS01-749 - LOCTITE PIPE SEALANT to x1) FP02-039 - NIPPLE-3/4 X 6 LG-BI and attach to the
opposite end of tee.
10. Apply MS01-749 - LOCTITE PIPE SEALANT to the opposite end of nipple and attach large end of x1)
FP01-216 - TEE-1/2 X 1/2 X 3/4 FI oriented as shown in relation to previous tee.
Page 2 of 21
Kit Instructions