Table of Contents
Advertisement
4.4 Battery
The stretcher is equipped with an acid-free buffer battery that allows height and inclination
adjustments even in the absence of a connection to the mains.
The capacity of the battery guarantees an autonomy of approximately 20 complete lifting/
lowering cycles.
The residual charge level is indicated by the indicator light (E).
The battery can be activated and deactivated via two buttons, ON and OFF, located on the
battery housing. The LED located next to the buttons indicates the status of the battery: if
GREEN the battery is charged, if ORANGE
GREEN
NOTE: if the battery is low, it emits an audible alarm each time the sections are moved.
To charge the battery, simply connect the power cable to the mains or use the battery charger
(accessory code 7M009042).
N.B.: leaving the power cable plugged in for long periods will in no way damage the battery. The
control unit is equipped with software that manages the charge optimally.
Even in the case of a completely depleted battery, it is still possible to use the stretcher. In this
case it will not be possible to adjust the height of the bed surface.
4.4.1 Fitting the battery
To fit the battery proceed as follows:
▪ assume a position at the head side of the stretcher and open the velcro strap;
▪ insert the battery into the battery housing (Fig. 1);
▪ do not release the battery before having heard the locking "click" and having wrapped the
Velcro safety strap around the battery body;
▪ connect the power plug of the stretcher to the power outlet: the battery will start charging and
the LED of the battery and of the console (E) will start flashing ORANGE; when the battery
has completed charging, the LED will turn GREEN.
Fig. 1
12
ORANGE the battery is low.
Green led on
Press ON
Battery housing
Velcro strap
Fig. 2
ID05449 - Rev. 0.1 - 01/12/2020
Advertisement
Table of Contents
