Table of Contents
Advertisement
4.4.2 To disassemble/replace the battery with accessory code 7M009042 Additional
battery complete with desk / wall battery charger
WARNING! Pressing the release lever, the battery immediately disengages from
the support so be sure to be holding it properly.
To disassemble the battery proceed as follows:
▪ with one hand hold the battery and with the other open the velcro strap;
▪ press the battery release lever (image below) being sure to support it properly (Fig. 2);
▪ connect the battery charger to the power socket and connect the battery; an ORANGE LED
on the battery charger transformer will light up to indicate that the battery is charging; the
charging time can take from 4 to 12 hours depending on the remaining charge;
▪ when the battery is fully charged, the LED will light up GREEN;
▪ disconnect the battery from the battery charger and insert it back into the stretcher;
▪ turn on the battery by pressing the ON button on the battery housing on the stretcher: a
GREEN LED will light up indicating that the battery is on and charging.
Battery release
lever
ID05449 - Rev. 0.1 - 01/12/2020
Wall/wall battery charger
13
Advertisement
Table of Contents
