Table of Contents
Advertisement
11.4.6 Installing the variable-height monitor/tablet-holder
WARNING! This item must be installed by a nurse.
To install the monitor/tablet-holder at variable height proceed as follows:
▪ insert the pole (1) into the support by means of the nylon bushing (5) as shown below;
▪ if necessary, adjust the height: with one hand support the pole (1) and with the other raise
the fixing lever (4), adjust the height and lock the position by lowering the lever (4);
▪ check its stability.
11.4.7 Functional test
ATTENTION! The following check must be repeated periodically to verify the
efficiency of the product.
Before putting the item into use:
▪ check if it works correctly by referring to the paragraph "Operation and use" of this accessory;
▪ if the check is successful, the item is ready to be put into regular service, otherwise contact
Customer Service immediately.
11.4.8 Operation and use
ATTENTION! Do not use the item for any purpose other than the following.
WARNING! Never exceed the safe work load of the accessory.
WARNING! Always make sure the item is securely attached to the stretcher before
putting it into use.
WARNING! The tools must not in any way protrude from the configuration of the
stretcher, as they could hinder the movements of the stretcher, could be in the way
and therefore cause injuries to the operator and patient resulting from a possible
fall, and cause damage to the stretcher itself.
To use the variable-height monitor/tablet-holder proceed as follows:
▪ ensure its stability, place the monitor/tablet on it and secure it by means of the straps (3).
ID05449 - Rev. 0.1 - 01/12/2020
39
Advertisement
Table of Contents
