Media Setup - Intermec EasyCoder PD42 User Manual

Data Dump
Memory Reset
LSS Test

Media Setup

EasyCoder PD42 Printer User's Guide
If data dump is enabled by selecting the "Yes" option, the printer
listens on all ports and prints all data and protocol characters
received. An ASCII and hexadecimal representation of each
character is printed.
This feature allows you to reset the factory default settings of the
printer. There are two options:
• All. Select this option to reset the entire memory.
• Configuration. Select this option to reset the Configuration
part of the memory only.
This function allows you to test that the Label Gap Sensor (also
referred to as Label Stop Sensor, or LSS) is working properly.
Please see "Adjusting the Label Gap Sensor" on page
The media parameters tell the firmware the characteristics of the
media that will be used, so the printout will be positioned
correctly with optimal quality.
Media Type
The Media Type parameters control how the label stop sensor
(LSS) and the media feed work. There are three media type
options:
• Gap is used for adhesive labels mounted on liner (backing
paper) or continuous paper stock with detection slots.
Default.
• Mark is used for labels, tickets, or strip provided with black
marks at the back.
• Continuous is used for continuous stock without any
detection slots or black marks.
Appendix D — Setup Parameters (IPL)
53.
109