Intermec EasyCoder PD42 User Manual page 105

EasyCoder PD42 Printer User's Guide
Appendix C — Setup Parameters (Fingerprint)
The following table gives initial recommendations for suitable
settings.
Direct Thermal Recommmended Settings
Paper Label
sensitivity Constant
Low 100
Standard 90
High 80
Ultra High 70
Use the above settings as initial settings and adjust the Label
Constant if necessary.
Thermal Transfer printing
• Ribbon Constant (range 50 to 115). Default is 90.
• Ribbon Factor (range 10 to 50). Default is 25.
• Label Offset (range -50 to 50). Default is 0.
The following tables gives initial recommendations for suitable
settings.
Thermal Transfer Recommended Settings
Ribbon
Ribbon Constant
Wax 80
Hybrid 90
(Wax/Resin)
Resin 100
The receiving material has been excluded from this table, since
the ribbon has the largest impact for heat settings for thermal
transfer settings.
Use the above settings as initial values, and adjust the Ribbon
Constant if necessary.
Max Print
Label Speed (203
Factor dpi
40 75
40 100
40 125
40 150
Max Print
Ribbon Speed (203
Factor dpi
20 75
25 100-150
30 150
Max Print
Speed (300
dpi)
50
75
100
100
Max Print
Speed (300
dpi)
75
75-100
100
95