Procedure to set the airflow set points (continue)
PROCEDURE
9 Set the maximum limit for fan
speed.
Not used for all models.
10 Set the dual duct minimum
airflow.
Not used for all models.
11 Select a new configuration
function or exit.
Advanced Options
The advanced options set up passwords and special features in the controller.
• Establish or change Password 1 and Password 2
• Set timers for standby and override (optional)
• Enable automatic occupancy (optional)
• Enable discharge air temperature control (optional)
• Calibrate the sensor
Setting the advance options requires entering Password 2 which is described in the topic Getting started with configuration on
page 14.
Tip:
Once the following procedure is started, all steps must be completed in order.
Procedure to set the advanced options
PROCEDURE
1 Starting display
Date: 10-2016
Supersedes: 7-2016
Nailor reserves the right to change any information concerning product or specification without notice or obligation.
Installation and Operation Manual
∆
1. Press the
or
for the fan speed. The set point will change in 1%
increments.
2. Press the
button to save the set point and
advance to the next function.
1. This set point is for the minimum airflow when a Dual
duct system is at temperature set point.
∆
1. Press the
or
2. Press the
button to save the set point and
advance to the next function.
∆
1. Press the
or
following:
• STPT, BOX, ADVC, or RSTR options
• BACK to choose another configuration function
EXIT.
2. Press the
button to select the next function.
1. Start at the temperature display.
∆
2. Press the
and
• If Password 2 is not required, the display changes
to CNFG.
• If required, enter Password 2. The display changes
to CNFG when Password 2 is correct.
Page 21 of 48
EZvav Digital Controls
●
STEPS
buttons to set the maximum limit
buttons.
buttons to select one of the
STEPS
buttons together.
STE DISPLAY
-!8&
//
$,-.
//
FLOW
STE DISPLAY
3
237
////
IOM-EZVAVINST