Configuring The Vav Terminal Unit Options - Nailor 37S Manual

Procedure to set the temperature set points (continue)
PROCEDURE
11 Set the standby differential set
point.
12 Select a new configuration
function or exit.
Configuring the VAV Terminal Unit Options
The unit options set the controller for the specific mechanical installation of the VAV terminal unit. The unit options include the
following items.
• The K-factor for the VAV terminal unit. If the K-factor is not available, see the topic K-factors on page 47.
• Reheat configuration (optional)
• Fan configuration (optional)
• Direction of damper to close
Setting the unit options requires entering Password 2 which is described in the topic Getting started with configuration on page 14.
Tip: Once the following procedure is started, all steps must be completed in order.
Procedure to set the Terminal Unit functions
PROCEDURE
1 Starting display
Date: 10-2016 Supersedes: 7-2016
Nailor reserves the right to change any information concerning product or specification without notice or obligation.
Installation and Operation Manual
The standby set point is calculated by adding or
subtracting the offset value to or from the value of the
occupied set point.
∆
1. Press the or
differential set point. The set point will change in 1°
increments.
2. Press the button to save the set point and
advance to the next function.
∆
1. Press the or
following:
• BOX, FLOW, ADVC, or RSTR options
• BACK to choose another configuration
function.
• EXIT to return to the temperature display.
2. Press the button to select the next function.
1. Start at the temperature display.
∆
2. Press the and
• If Password 2 is not required, the display changes to
CNFG.
• If required, enter Password 2. The display changes to
CNFG when Password 2 is correct.
Page 17 of 48
EZvav Digital Controls
●
STEPS
buttons to set the standby
buttons to select one of the
STEPS
buttons together.
STE DISPLAY
STPT
STE DISPLAY

3
237
////
IOM-EZVAVINST