Hilti DX 76 Manual page 26

• It is a requirement for EFTA countries that the cartridges must be CE-compliant and must bear the CE
mark of compliance.
• It is a requirement for the United Kingdom that the cartridges must be UKCA-compliant and must bear
the UKCA mark of compliance.
• It is a requirement for the USA that the cartridges must be compliant with the stipulations set out in
ANSI A10.3-2020.
• It is a requirement for the non-European member states of the C.I.P. that the cartridges must have C.I.P.
approval for the DX fastening tool used.
• It is a requirement for the remaining countries that the cartridges must have passed the firing-residues
test in accordance with EN 16264 and must have a manufacturer's declaration to this effect.
Cartridges (as example: X-ENP)
Comply with the instructions for use in the operating instructions of the fastener used, in the Hilti
Direct Fastening Technology Manual or the corresponding local Hilti 'Technical Guide to Fastening
Technology'.
Ordering designation
6.8/18M cartridge
3.4 Minimum distances and edge distances
You must always observe certain minimum distances and spacing when driving fasteners. They can differ,
depending on the product.
Comply with the instructions for use in the operating instructions of the fastener used, in the Hilti
Direct Fastening Technology Manual or the corresponding local Hilti 'Technical Guide to Fastening
Technology'.
3.5 Information about the field of applications
For detailed information about areas of application, request a copy of the Hilti 'Direct Fastening Technology
Manual' or the corresponding local Hilti 'Technical Guide to Fastening Technology' from your Hilti Store.
4 Technical data
4.1 Product properties
Weight (fastening tool with magazine)
Dimensions
Magazine capacity
20 English
Color Power level
(charge)
black extra-strong
red very strong
blue strong
green Extra-light
4.35 kg
450 mm × 101 mm × 352 mm
10 fasteners
282470
*282470*