Intermec EasyCoder 201II Startup Manual page 12

Intermec Shell 4.01 Standard – Startup Manual
SETUP MODE, cont'd.
Step-by-Step Instructions,
cont'd.
• If you cannot make the paper feed operate properly by means of
TESTFEEDs, you will have to adjust the LSS as described below.
• Before the LSS is adjusted, the printer must be set up for the type
of paper web you intend to use, i.e. "Label (w gaps)", "Ticket (w
mark)", "Ticket (w gaps)", "Fix length strip", or "Var. length
strip". "Tickets (w mark)" is not available in all models.
• Label (w gaps):
Put a piece of paper with backing paper into the sensor. The cursor
should appear at the left side of the menu:
LABEL <103> GAP
Put a piece of backing paper without any label into the sensor. The
cursor should move to the centre of the menu:
LABEL <103> GAP
Finally remove all paper web from the sensor. The cursor should
move to the right side of the menu:
LABEL <103> GAP
• Ticket (w mark), certain models only:
Put the paper into the sensor so there is no black mark close to the
LSS. The cursor should appear at the right side of the menu:
MARK <103>TICKET
Move the paper so the black mark becomes situated between the
two parts of the sensor. The cursor should move to the left side of
the menu (the same applies when no paper is fitted):
MARK <103>TICKET
• Ticket (w gaps), Fix Length Strip and Var. Length Strip:
Put the paper into the sensor, making sure there is no gap close to
the LSS. The cursor should appear at the left side of the menu:
LABEL <103> GAP
In case of tickets, move the paper so the gap becomes situated
above the sensor. In case of strip, remove the paper completely.
In both cases, the cursor should move to the left side of the menu:
LABEL <103> GAP
Continued!
11