Using Terminal Setup - Intermec EasyCoder 201II Startup Manual

Intermec Shell 4.01 Standard – Startup Manual
TERMINAL SETUP, cont'd.

Using Terminal Setup

The Terminal Setup program is self-instructing by means of prompts.
You can move around in Intermec Shell in the same manner as when
you control Intermec Shell manually by means of the printer's
display, <Print> key and Headlift.
The Setup part of Terminal Setup follows the same structure as
setup files, see later in this chapter. Comprehensive explanations of
the various setup parameters can be found in the Technical Manual
for the printer model in question.
When you transmit the triple T (TTT/ttt) to the printer, the following
message will appear on printer's display:
SETUP FROM
TERMINAL
On the screen of the host, another message will appear:
-----------------------------------------------
Welcome to SHELL v.4.01 in terminal mode
-----------------------------------------------
Answer Y <CR> for Yes, <CR> for No.
----------------
SHELL
SEL. APPLICATION
----------------
(Y / N):
From here on, you can move around in Intermec Shell according to
the diagram in the chapter "Using Intermec Shell" by answering Y
(=Yes) or N (=No) to the prompts that successively appear on the
screen.
Note that the program also accepts the corresponding lowercase
characters, e.g. y and n.
15