Printer Defaults - Intermec 6820 Technical Reference Manual

Cross-Reference Tables
Decimal
ESC "P"
ESC "Q" n
ESC "R" n0 n1 n2
ESC "R" n
ESC "S" 0*
ESC "S" 1*
ESC "T"
ESC "U" 0*
ESC "U" 1*
ESC "W" 0*
ESC "W" 1*
ESC "Y" n1 n2
ESC "Z" n1 n2
ESC "^" (0) n1 n2
ESC "^" (1) n1 n2
ESC "b" c
ESC "b" c n1 n2 ... nk
ESC "j" n
ESC "l" n
ESC "s" 0*
ESC "s" 1*
ESC "t" (0)
ESC "t" (1)
ESC "z" n
ESC "\" n1 n2

Printer Defaults

The Table 5-4 settings are installed in the printer at the factory. To restore these
defaults, refer to the Changing the Printer Settings paragraph, in the
Maintenance section of the User's Guide.
Function
Carriage position
Character set
Codepage
Codes 128--255
Condensed (compressed)
Double-strike
Double-Wide
Emphasized
Graphics mode
Half-speed printing
5-10 6820 Printer Technical Reference
Table 5-3 (Continued)
Escape Sequences Quick Reference
NUL
NUL
Table 5-4
Factory Default Printer Settings
Description
Select Pica Pitch
Set Right Margin
Codepage Selection
Select National Character Set
Select Superscript Mode
Select Subscript Mode
Cancel Superscript/Subscript Mode
Cancel Unidirectional Printing
Select Unidirectional Printing
Cancel Double-Wide (expanded) Mode
Select Double-Wide (expanded) Mode
Select High-Speed Double-Density Graphics Mode
Select Low-Speed Quadruple-Density Graphics Mode
Select 9-pin Single Density Graphics Mode
Select 9-pin Double Density Graphics Mode
Clear Vertical Tab Channel
Set Vertical Tabs in Channel
Perform n/216 inch Reverse Line Feed
Set Left Margin
Cancel Half-speed Printing
Select Half-speed Printing
Disable Printing of Character Graphics
Enable Printing of Character Graphics
Set Inactivity Time for Sleep mode
Set Print Position (relative)
Default Value
At left margin
Normal (not user defined)
0
Disabled
Disabled
Disabled
Disabled
Disabled
Not selected
Disabled
SECTION 5